2nd Gen Camaro PowerBraid Kit P/N 70923
Part Number: 70923
Finish the job right with this complete PowerBraid kit for use with any of the following 2nd gen Camaro harnesses: 20112, 20113, or 20114. Contains all the appropriate diameter wire wrap, ties, and tape.
PowerBraid is a flexible, semi-rigid material, with a tough woven texture and appearance to enhance the look and protect the insulation of any electrical wire bundles or cables. The woven construction provides good drainage while maintaining superior abrasion resistance. The split loom design has a minimum overlap of 25% to allow for easy installation and optimum wiring protection.
- Continuous Temperature Rating -94° to 257 °F
- Melting Point 482°F
This kit includes:
- 2 ft. – 1” PowerBraid
- 2 ft. - ¾” PowerBraid
- 33 ft. - ½” PowerBraid
- 70 ft. - ¼ PowerBraid
- 41 ft. – 1/8” PowerBraid
- 2 ft. - 3/8” Heat Shrink
- 2.5 ft. - ¼ Heat Shrink
- 1 ft. - ½ Heat Shrink
- 100 - 4in. Tie Wraps
- 40 - 7in Tie Wraps
- 1 roll - Electrical Tape
- 1 roll - Stretch and Seal Tape
Before: Not only is unprotected wiring an eye-sore, it also runs the risk of coming into contact with sharp edges and chemicals that can create headaches.
The split loom design is easy to install and provides a minimum 25% overlap to allow optimum wiring protection.
After: PowerBraid will transform your engine bay, giving you a clean look and great protection!
Prop 65 Warning
No Specs are available for this Part