Call Tech Support 1-800-423-9696

Tech Support: 1-800-423-9696
Thursday 04/19/2018
Open today at 8AM

 
2nd Gen Camaro ClassicBraid Kit By Painless Performance

P/N 70973

2nd Gen Camaro ClassicBraid Kit

     8 left in stock
       
 

  • Application
  • Specs
  • Larger Image
American Made

 

Finish the job right with this complete ClassicBraid kit for use with any of the following 2nd gen Camaro harnesses: 20112, 20113, or 20114. Contains all the appropriate diameter wire wrap, ties, and tape.

ClassicBraid is a self-wrapping split braided wiring loom for that classic show car look! Its smooth texture and appearance will transform your engine bay, giving you that factory installed look.

The tightly woven construction provides excellent blockage against mud and dirt, while maintaining adequate drainage. The split loom design has a minimum 25% overlap to allow for easy installation and optimum wiring protection.

  •  Continuous Temperature Rating -94° to 257°F
  •  Melting Point 482°F

 

This kit includes:

  • 2 ft. – 1” ClassicBraid
  • 2 ft. - ¾” ClassicBraid
  • 33 ft. - ½” ClassicBraid
  • 70 ft. - ¼ ClassicBraid
  • 41 ft. – 1/8” ClassicBraid
  • 2 ft. - 3/8” Heat Shrink
  • 2.5 ft. - ¼ Heat Shrink
  • 1 ft. - ½ Heat Shrink
  • 100 - 4in. Tie Wraps
  • 40 - 7in Tie Wraps
  • 1 roll - Electrical Tape
  • 2 rolls - Stretch and Seal Tape

Before:  Not only is unprotected wiring an eye-sore, it also runs the risk of coming into contact with sharp edges and chemicals that can create headaches.

 

The split loom design is easy to install and provides a minimum 25% overlap to allow optimum wiring protection. (PowerBraid shown)

 

After: ClassisBraid will transform your engine bay, giving you that clean factory installed look

 

 2nd Gen Camaro ClassicBraid Kit By Painless Performance