P/N 10202

18 Circuit Universal / Streetrod Harness / Non GM Keyed Column


  • Application
  • Specs
  • Accessories
  • Reviews
  • Larger Image

This 18 Circuit kit allows you to add accessories to the basic wiring such as power windows, door locks, etc. This kit does NOT include the GM column mounted ignition switch plugs but it does include the GM column mounted turn signal switch plugs and terminals.

 

This harness includes circuits for:

  1. Headlight Switch- Power to headlight switch.  Power wires out of headlight switch to head light dimmer switch, tail lights, dash lights and park lights.
  2. Dimmer Switch wires include power from headlight switch and power out to low and high beam headlights.
  3. Wiper Switch- Power to wiper switch.  You will need to retain the wires between the wiper switch and your wiper motor.
  4. Turn Signal Switch- Power into and out of your column mounted turn signal switch.  Also included in this kit are both styles of GM turn switch connectors.  Note: these will connect to most aftermarket and factory steering columns. 
  5. Ignition Switch- Power into and out of to fuse block (ignition, crank and accessory)
  6. Brake Switch- Power into and out of brake switch.  This includes a third brake light wire.
  7. Courtesy Lights- Power and ground circuits for dome light activation.
  8. Alternator- Charge wire and alternator field activation wires.  (Most alternators can easily be wired up to this Painless harness).  Included in kit is a high output alternator wire that allows you to use up to a 140 Amp alternator.
  9. Horn-  40 Amp horn relay mounted to fuseblock
  10. Radio- Harness includes constant B+ (for preset memory) and ignition hot circuits for any aftermarket or factory radio.  Also included are two pairs of speaker wires.
  11. Starter- Crank signal wire for starter solenoid.
  12. Engine section wires including electric choke, coil power, coil to tach signal, oil pressure, engine temperature, and A/C compressor clutch control wire.
  13. Headlight section wires including right and left high and low beam headlights, turn signals and park lights.
  14. Tail section wires including tail lights, brake lights, turn signal lights,  fuel gauge sender, third brake light, and reverse lights.
  15. Dash panel section wires including fuel, temperature, oil pressure, voltage, tachometer, speedometer, high beam and turn indicators and gauge illumination.
  16. Door section wires including power windows and locks.
  17. Accessory section wires including cruise control, power antenna, electric fuel pump and an cigarette lighter/accessory output.
  18. Also included in kit is a fuseblock mounting bracket, rubber grommet, 4 inch zip ties, 70 Amp maxi fuse and a large assortment of crimp style connectors.

Most important of all we provide an illustrated installation manual that equips you with the needed information to install the harness to your vehicle.  If you get stuck during the installation just give our tech line a call.  They have an immense data base of vehicle specific information.

GM 1982-1993 Throttle Body Fuel Injection Harness
GM 1986 - 1989 Tuned Port Fuel Injection Harness (MAF)
GM 1990 - 1992 Tuned Port Fuel Injection Harness (MAP)
PERFECT Vehicle Speed Sensor Signal generator
GM 1982-1993 Throttle Body Fuel Injection Harness Extra Length
GM 1986 - 1989 Tuned Port Fuel Injection Harness (MAF) Extra Length
GM 1990 - 1992 Tuned Port Fuel Injection Harness (MAP) Extra Length
GM 1992 - 1995 Vortec (CMFI) V6 Fuel Injection Harness

70-Amp Fan Relay Kit
Fan-Thom Electric Fan Relay Kit
Brake Light Relay Kit
3-Pack Relay Bank
6-Pack Relay Bank
PCM Controlled Fan Relay Kit (Ground Activated)
Dual Activation Electric Fan Relay Kit (195°F On/185°F Off)
Dual Activation Electric Fan Relay Kit (185°F On/175°F Off)

 


See More...
Fuel Injection Harnesses | Relays | PowerBraid Kits | Accessories

Customer Reviews

Brian Nussle
 
Date: Tuesday, 2nd February 2010
This is my 9th install of a Painless Harness. I have used others, but will only use Painless in my car(s) and recommend only Painless Products to my customers.
 

Gabe Robbins
 
Date: Tuesday, 3rd November 2009
Nice looking kit - I've installed other brands before, but this one seems high quality.
 

Add Your Review

Rate it! Thanks for your rating!
  A value is required.
Name: Please Enter Your Name.
Email: Please Enter Your Email Address.Invalid format.
Comment:   Please Enter your Comments.At Least 5 characters required.Exceeded maximum number of characters.
To help stop spammers answer the question below and hit submit
What is 20 + 10? Please Enter the total of 20 + 10 .That's not right, Try again.The number you entered is not the total of 20 + 10.The number you entered is not the total of 20 + 10.