Painless Performance: Striker ColdShot Water/Methanol Injection System for Diesel

THIS KIT IS A PAINLESS DESIGN GUARANTEED TO FIT YOUR TURBO DIESEL VEHICLE, NO OTHER KIT COMES CLOSE.

The highest quality, most complete water/methanol injection system on the market. The on-board control monitor features an LED gauge displaying boost pressure from 0 to 100 PSI in both analog and digital format and a 60 LED display of the programmable injection curve. The controller features a low-water level warning indicator and a dimming function for night and day brightness.

Lower your intake, combustion and exhaust temperatures by injecting water/methanol using the Striker ColdShot. After injection, evaporation of the water and methanol absorbs energy in the form of heat from the post intercooler intake air. Cooling of the intake air temperature produces an air charge more dense with oxygen. Evaporated methanol enters the combustion chamber and increases the octane of the combustible fuel. Residual water/methanol droplets also enter the combustion chamber. These droplets absorb heat from the cylinder walls, pistons and heads. At ignition, evaporation/burn of the water/methanol finishes. More heat is absorbed with a resultant of lower combustion and exhaust temperatures. Cooler exhaust temperatures extend the life of your turbocharger.

Great With Stacked Power Modules

This kit features: Very Fine Mist (VFM) custom made industrial grade nozzles for superior atomization, high pressure pump, industrial quality 12 volt solenoid, 2 quart tank with level sensor and custom made wiring harness with all needed connectors.

Click here to see how it works.

Includes 7 gallon tank 2 nozzle bushings and everything you see below.

State-of-the-Art Controller with digital and analog boost gauges. Easy on-the-fly programming. Progressive injection control module.

25 Ft of 1/4 inch tubing allowing you to mount your pump and reservoir in any location. Shurflo Water/Methanol pump engineered specifically for the ColdShot System.

12 Volt Solenoid for back flow and gravity feed prevention. 7 Quart reservoir with Vented Cap, Threaded Port for Tube Fitting and Level Sensor.

Waterproof connectors for durability and longivity
Fused ingnition relay pigtail to safely power the ColdShot System without overloading your factory fuseblock.

Specifically engineered Harness by Painless Performance ™. Every wire in this Harness is 15 ft long and TXL automotive grade. With preterminated Progressive Control Module and Display connectors.
More than enough Mounting hardware to best suit your installation needs.

Make it Easy, Make it Simple, Make it Painless